Lane Departure Assist System

The lane departure assist system switch is located on the central screen. The system can be turned on/off in the appropriate interface under “ADAS”, and the mode selection can be made.

• The function is in ON state;
• The vehicle speed is above 37mph (60km/h);
• The lane lines are clear, and the system detects the lane lines on both sides. When the wheel is about to cross the lane line or has already crossed the lane line, the system will provide warnings to remind the driver to correct the direction in time and keep the vehicle running within the lane lines. The function will exit when the speed drops below 34mph (55km/h). Note: When the vehicle deviates from the lane for the first time, the system does not sound an alarm, only an visual alarm. When there is a subsequent lane departure, there will be an audible alarm, and the more frequent the deviation, the longer the alarm will sound. Warning + Assistance The system detects the lane lines ahead. When the following detection conditions are met:
• The function is in ON state;
• The vehicle speed is above 37mph (60km/h);
• The lane lines are clear, and the system detects the lane lines on both sides. If the vehicle is about run on the solid lane line or drive into the kerb, the system will assist the driver in keeping the vehicle traveling within the lane lines by applying corrective steering intervention and prompting. If the vehicle deviates too much from the lane line, the warning function will be triggered at the same time. The function will exit when the speed drops below 34mph (55km/h).